CHD Elektroservis   MP-KBD - Korg Mono/Poly MIDI Keyboard Interface v.1.0   Help
Parameters

MIDI Channel
Number of receiving MIDI channel or OMNI mode can be set by this parameter.

Key Shift
Parameter sets number of MIDI Note which corresponds to the lowest key of Mono/Poly keyboard.

Key Priority
Parameter sets priority mode of key assigning if more than 4 MIDI notes are received.
LAST - the last pressed key always replaces the first key pressed.
HIGHER - if the last pressed key is of higher tone than any of the previously pressed keys, the lowest key tone is replaced.
LOWER - if the last pressed key is of lower tone than any of the previously pressed keys, the highest key tone is replaced.
NONE - if all four tone generators are being used, all next Note On commands are ignored at the MIDI input.

Pitch Wheel Range
Parameter sets maximum possible range (+- semitones) of Pitch Wheel (Pitch Bend) command. If zero value is set, Pitch Wheel has no effect. Maximum is +-2 octaves.

Arpg Clock Rate
Parameter sets source of clock pulses for arpeggiator. MIDI clock pulses are selected for values 1 to 127 - see examples:

Parameter valueArpeggio Rate
1271/64 triplet
1261/32 triplet
1251/32 note
1241/16 triplet
1221/16 note
1201/8 triplet
1161/8 note
1121/4 triplet
1041/4 note
961/2 triplet
801/2 note
641/1 triplet
321/1 note

 

SysEx Msg

Hex Byte Form
Text form of hexadecimal bytes can be chosen by this select-box. Requested form must be selected before any "Generate" or "Generate All" button is pressed.

Delimiter
Delimiter between generated hexadecimal bytes can be chosen by this select-box. Requested delimiter must be selected before any "Generate" or "Generate All" button is pressed.
 

Buttons

Generate
Message for temporary change of the only one parameter will be generated if any of these buttons is pressed. Value of the parameter must be set before.

Generate All
Message for permanent change of all parameters in internal memory will be generated if this button is pressed. Values of all parameters must be set before.

Reset
This button sets all parameters to their default values.